Laserjet Enterprise M507X Setup

 Start with unpacking the printer to perform the hardware setup of the HP Laserjet Enterprise M507X printer.

Make sure to take all the packing and protective materials inside and outside the machine.

Press the release button to open the front cover of the machine. Place the new toner cartridge after unpacking it from the package.

Close the HP Laserjet Enterprise M507X printer’s front cover properly.

Pull and lift the paper tray 2 to remove it from the machine. Slide the adjustment latches and paper guides to fit some plain paper in the paper tray 2.

Use the power cable to connect its one end to the rear port of the HP Laserjet Enterprise M507X printer.

The power cord’s other end should be plugged into the AC power outlet.

Search for the Power button on the left side of the machine and hold it. This will power on the HP Laserjet Enterprise M507X printer.

On the machine’s control panel, set your language, date/time, and time zone for the machine.

Make sure to enable the USB port of the machine. This feature is disabled by default.

Select the General option from the Settings list. Select the Enable Device USB option followed by the Enabled option.

Do not plug the USB cable until you see the prompt message to establish a USB cable connection while installing the driver of the HP Laserjet Enterprise M507X printer.

Install the product software on your computer.

Popular posts from this blog

How to Setup HP LaserJet M234dwe Printer?

HP DESKJET 3752 SCAN TO COMPUTER

How To Reset Ink Cartridge HP 61?