How To Install HP Deskjet 3755
Unboxing the printer :
First, take out all the protective materials from the outside of the printer.
Next, remove the protective materials from inside the printer.
If there are any orange tapes, remove them too.
Please discard all the protective materials and orange tapes.
Do not forget to recycle all the discarded materials.
Choosing a location for the printer :
Please select a flat, sturdy surface to keep your printer.
If you have to shift the printer from one location to another, at least 2 people will be needed for the task.
Power connection for the printer :
Take hold of the power cable. Then, connect one end of the power cable to the rear port of your printer. Then, plug the other end into the electrical outlet.
Once you have finished the power connections, you can start loading paper into your printer. Please make sure that you use only the recommended HP paper for your printer.
Installing the Cartridges :
Lower the cartridge access door and wait while the carriage moves to the center and halts.
Peel off the orange tapes from the cartridges.
Make sure that you install each of the cartridges in the respective colored slots.
Wait for the printer to complete the initialization.
Loading Plain paper :
Raise the input tray of the printer and then pull out the extender.
Fan a stack of paper and place them in the tray.
Locate the input tray shield at the bottom of the tray and pull it back. Now, while holding the shield, adjust the guides to fit the paper width.
At the bottom of the printer, extend the output tray and raise the paper catch.
Once you have completed the printer hardware setup, you can go ahead and install the software for your HP Deskjet 3755 printer.